Tabletop Scanner Preparation
- Scanners and accessories (T710 / T510 / T310)
- [Medit Scan for Labs v.1.7.0] Medit Scan for Labs Introduction
- [Medit Scan for Labs v.1.7.0] General
- [Medit Scan for Labs v.1.7.0] System Requirements
- [Medit Scan for Labs v.1.7.0] Installation of Medit Scan for Labs
- [Medit Scan for Labs v.1.7.0] Hardware Configuration
Getting Started
Scanning Guide
Workflow
- [Medit Scan for Labs v.1.7.0] Scan the Bottom Side of Wax-Up
- [Medit Scan for Labs v.1.7.0] Scan Body Library Alignment
- [Medit Scan for Labs v.1.7.0] Post and Core
- [Medit Scan for Labs v.1.7.0] Flexible Multi-Die
- [Medit Scan for Labs v.1.7.0] Fill Holes for Abutments
- [Medit Scan for Labs v.1.7.0] Remove Base from Gingiva Scan
Troubleshooting
- Failed to Connect due to IP Address Conflict
- Scanner connection issues when connecting an internet cable and a scanner to USB ports using the same chipset.
- The scanner connection failed with the message "Administrator privilege is required."
- exocad > Medit Link fails to load the project file of exocad
- T710/T510/T310 > Cannot connect to the tabletop scanner.