Confirm
This stage allows users to check and edit the aligned data if necessary.
To edit the data, use the area selection/deselection tools and the "Adjust Occlusion Height" tool.
Adjust Occlusion Height
After scanning the occlusion, you can adjust the bite height as needed. This tool is useful when creating a splint or denture, as you can adjust the height without scanning the occlusion a second time.
Only the maxillary data can be moved to adjust the occlusion height.
1. Complete the scanning of the maxilla, mandible, and occlusion.
2. Click the "Adjust Occlusion Height" icon at the Confirm stage.
3. Set the "Maxilla Movement Value (mm)" option and move the maxillary data upward or downward.
4. Click the "Exit" icon to complete.
Confirm Stage Tools
 |
Free Selection | Allow you to select an area freely. |
 |
Rectangular Selection | Allow you to select a rectangular region. |
 |
Island Selection | Allow you to select all connected data by clicking on a point. |
 |
Surface-Only Selection | When on, allow you to select only the surface of data using the area selection tools. |
 |
Deselection Mode | When on, deselect the selected area. |
 |
Adjust Occlusion Height | Adjust the occlusion height using the provided tools below. |
The following tools are provided when entering the "Adjust Occlusion Height" tool.
 |
Reset Occlusion Height | Reset the occlusion height of the maxilla. |
 |
Move Maxilla Up | Move the maxilla upwards by the set maxillary movement value. |
 |
Move Maxilla Down | Move the maxilla downwards by the set maxillary movement value. |