The following options need to be configured for scanning the model.
❏ Scanbody alignment
- Select the scanning strategy for scanbodies.
All: Merges and aligns the data from scan body and base simultaneously.
Group: Select this option to divide the scanning process into three stages: Scanbody without base, Scanbody Group 1, Scanbody Group 2. Scan them separately by category and align them at Align Data step. (This option can be selected when scanbodies are overlapped or when base data is needed for the missing part of scanbody.)
- All / Group scan stages example)
❏ Gingiva
- Select to perform the scan with or without gingiva.
With gum: Select this option to scan and align gingiva separately.
Without gum: In cases where gingiva is absent, there is no separate alignment process for gingiva.
❏ Prepared teeth
- Select the data to be aligned with prepared tooth scan data.
Flexible multi-die: Select this option to scan the prepared teeth all together using flexible multi-die.
Base: Select this option to scan the prepared tooth in the base. Remove all the adjacent teeth from the base and perform the scan by dividing prepared teeth into group 1 and group 2.
Solid: Select this option when the prepared tooth cannot be detached from the solid model. There is no separate scan stage for the prepared tooth, but the scanning can be done using many cuts.
- Scan stages example)
❏ Interproximal
- Select this option to acquire additional data for the interproximal areas.
Off: Scan the arch using the general method.
On: Select this option for the case that requires additional lingual measurements. Put the model on the buccal side to scan it in the upright position.
- Scan stages example)
