1. Create form information by entering tooth type, option, and notes, and then click Save & Scan.
- Implant scan > Custom abutment
- Gingiva scan > Yes
2. Complete the scan strategy setting, and click Confirm.
- Scan model type > Model
- Mandible > SCanbody and base model > Separate
3. Insert the model, in which the scanbody is not placed, to the scanner. Adjust the scan depth, and start scan.
4. The scan is complete.
- Check whether all scan images are acquired for necessary areas. If not, perform additional scan.
5. Insert the model, in which the scanbody is placed, to the scanner. Adjust the scan depth, and start scan.
6. The scan is complete.
- Check whether all scan images are acquired for necessary areas. If not, perform additional scan.
7. Insert the model, in which the gingiva is placed, to the scanner. Adjust the scan depth, and start scan.
8. The scan is complete.
- Check whether all scan images are acquired for necessary areas. If not, perform additional scan.
9. Align the scanbody data and the base model data by manual.
- 1 point or 3 points can be used for alignment.
- Mark alignment points onto the scanbody data and the base model respectively.
10. Align the gingiva data and the base model data by manual.
- 1 point or 3 points can be used for alignment.
- Mark alignment points onto the gingiva data and the base model respectively.
11. The alignment has been completed.
12. Remove unnecessary scan data by using editing tools, and then click Next to start the merging process.
- Tip: Select the areas to keep, invert the selection, and then remove unnecessary data.
13. Check the merged scan data, and click Exit to save and complete the case.
