[colLab] An orthodontic model

 

1. Create form information by entering tooth type, option, and notes, and then click Save & Scan.

• Project type > Orthodontic

2. Complete the scan strategy setting, and click Confirm.

• Occlusion scan type > Etc

3. Insert the flexible multi-die, in which the maxillary model is placed,  to the scanner. Adjust the scan depth, and start scan.

4. The maxillary model has been scanned.

• Check whether all scan images are acquired for necessary areas. If not, perform additional scan.

5. Scan the mandibular model in the same way as the maxilla.

6. Scan the occlusion.

7. Align the maxilla and the occlusion by manual.

• 1 point or 3 points can be used for alignment.
• Mark alignment points onto the maxilla and the occlusion respectively.

8. Align the mandible and the occlusion by manual.

• 1 point or 3 points can be used for alignment.
• Mark alignment points onto the mandible and the occlusion respectively.

9. The alignment is complete.

10. Remove unnecessary scan data by using editing tools, and then click Next to start the merging process.

11. Check the merged scan data, and click Exit to save and complete the case.