[colLab] Installing colLab 2017

1. Prepare the installer file

• Connect the USB drive, came with the scanner package, to the PC.
• There are two different installer files in USB flash drive.

- colLabSetup.exe: installs only the colLab software. During the installation process, you will be asked  to choose whether to connect the colLab program with the exocad program that you already installed on your PC. Refer to the guide 2-2.

- colLabsetup_exocad.exe: installs both the colLab software and exocad. Refer to the guide 2-1.

 

2-1. Installing the colLab software with exocad

• Run colLabSetup_exocad.exe in the installer folder.

• Select your language preference and click Next.

• Choose a folder to install the program to and tick the checkbox to agree to the License terms and conditions.

• Before proceeding, make sure the scanner is turned off. Click Next and then click OK to move to the next step.

• The installation process will start automatically, and may take several minutes depending on your computer's performance. 

• Restart the computer once installation is complete.

2-2. Linking colLab with exocad after installing the colLab software.

• Run colLabSetup.exe in the installer folder.

• Select your language preference and click Next.

• Choose a folder to install the program to and tick the checkbox to agree to the License terms and conditions.

• Before proceeding, make sure the scanner is turned off. Click Next and then click OK to move to the next step to choose whether you wish to link colLab 2017 to exocad.

• After choosing to link colLab 2017 to exocad, browse the Dental DB file and then click Install.

• The installation process will start automatically, and it may take several minutes depending on computer performance. 

• Restart the computer once installation is complete.